Description
Workman Electronics IC2000 Replacement 12 Volt DC Power Cord Plug For Many Alinco, Kenwood, Icom, and Yaesu HF Radios The Workman IC2000 is a direct replacement, 12 Volt power cord plug for Alinco, Kenwood, Icom and Yaesu Transceivers, used to repair/replace or build 12 VDC power cords. It is an older "standard" plug for many VHF and UHF transceivers and comes with many newer rigs, like Baofeng and other entry level radios on the market today.and if the plug in the picture matches your plug (and mates with the jack on your rig), it will work with your radio. Comes complete with installed male connector AND a ready-to-install female connector with pins. The other end of the cable is bare for installation as needed on your 12 Volt DC power source. PLEASE look closely at the connector detail in the pictures. If the pin layout is the same, this is the correct plug for your radio. Workman IC-2000 Replacement 12 Volt DC Power Cord with "T" Type Connector for Alinco, Kenwood, Icom, Yaesu VHF / UHF Radios. Very popular power cord for many VHF and UHF radios. Features the T shaped plastic connector that commonly plugs into the "pigtail" style of power connector. Features: * 15 Foot Red/Black Zip Cord * Installed Female "T" plug on one end * Ready-To-Install Male "T" Plug * (2) Fuse Holders with 10 Amp Fuses * For Icom, Alinco, Yaesu Radios and many more using the standard "T" plug Great for use as a quick disconnect. Replacement Fuses are available! BRAND NEW PRODUCT! Service Pledge: We strive for 100% Positive Feedback! If not completely satisfied with your purchase, please contact us BEFORE leaving feedback. We promise to discuss and mutually resolve all problems or mistakes immediately. Negative Feedback should never be necessary.